ENGEL Exhibited Injection Molding Technology at Plastpol 2011

SpecialChem - Jun 7, 2011

ENGEL couples innovative injection molding technology with peak efficiency and cost effectiveness. The injection molding machine manufacturer and automation expert has demonstrated its high level of system solutions competence at Plastpol held recently in Kielce/Poland. At Plastpol 2011, International Fair for Plastics and Rubber Processing (as the fair is to be called in future) ENGEL had presented processing of cross-linking and thermoplastic elastomers. For this purpose it will be using a vertical ENGEL elast 750/250 V type machine and a 4+4 cavity mould from ORP Stampi in which two pen casings and caps are produced in one cycle each. They will be moulded from type HTV-80ShA hard silicone from PMG. ENGEL duo...

This document was provided by SpecialChem's editor. If you want to share your press release, please send it to chief-editor-om@omnexus.com. SpecialChem reserves the right to refuse any article or news item.

Plastics & Elastomers Bi-Monthly Innovation Review
Omnexus Daily Newsletter
About SpecialChem - About Omnexus - Commercial Acceleration Services - Advertise with us
Contact Us - Forgot Your UserID/Password? - Site Map - RSS - Terms and Conditions - specialchem.com
Copyright @ 2014 SpecialChem - Omnexus